Sub-Zero Repair in Lake Hills, Bellevue

The owner’s list from Sub-Zero

For frost, condensation or ice inside the unit, the Designer guide asks for four things: a clean condenser, a door or drawer that closes properly, one that has not been left ajar, and a gasket with no rips or tears. For heavy icing it describes turning the unit off and melting the ice with a hair dryer set on low and kept moving, then wiping up the water.

Where the frost forms decides the next step

Frost gathered along the door edge, on the gasket or on the front of the first basket, points at air getting in. Frost spread evenly over the back wall or the coil cover, with a door that seals, points at the defrost side: the heater, its sensor or the control that runs it. We measure the door first and reach for defrost parts only once the seal has passed.

Remodelled openings

A remodel can set an integrated column into an opening first framed for another unit. Sub-Zero wants the column levelled against the floor it stands on rather than the cabinets beside it, and its installation guide names door closing among the things that suffer when that reference is wrong. A door left a fraction short of closed is enough to grow frost.

The visit runs from the tag to the door, the level and then the defrost parts, and ends with a price for the whole job before any part is ordered, less the $89 service call. Phantom Lake, Robinswood and West Lake Sammamish are covered the same way.